The NGusb

The following describes what you need to start construction of the NGusb connectivity board that can be used to initialize, flash and connect to the NG hardware in a comfortable way.

Getting the needed PCBs

Check out the UAVP-NG Shop to order your NGusb PCBs.

Getting the needed parts

Check out the NGusb part list to find out the components you need to build an NGusb.

Soldering

Solder all parts according to part list. LED1 anode directs to R1 (triangle to the USB-connector).

Drivers

Virtual COM Port Drivers for the FT232 can be found on FTDI´s website.

Description of the connectors and jumpers

Normal operation

For normal operation, set the jumpers as shown above.

Crossover operation

For crossover operation with rx/tx lines swapped, set the jumpers as shown above.

Power supply

The NGusb can provide 3.3V or 5V to the attached device.

Do not set any jumper for self-powered devices (such as the NG!).

3.3V mode

5V mode

UART-Connector

From Left to Right: GND, TXD, RXD, VCC